3-30 Service Manual
5058-030
4. Push the green lever back into place.
5. Close door A.
6. If necessary, touch Continue from the printer control panel.
Paper jam under the fuser
1. Open door A by lifting the release latch and lowering the door.
2. If the jammed paper is visible under the fuser, then firmly grasp the paper on each side, and then gently
pull it out.
Note: Make sure all paper fragments are removed.
3. Close door A.
4. If necessary, touch Continue from the printer control panel.
CAUTION—HOT SURFACE:
The inside of the printer might be hot. To reduce the risk of injury from a hot component, allow
the surface to cool before touching.
To Next Page
Loading...
