Repair information 4-57
5058-030
8. Remove the inner cover. See “Inner cover removal” on page 4-3.
9. Remove the inner plate. See “Inner plate removal” on page 4-92.
10. Remove the ATC sensor PCB bracket. See “ATC sensor PCB bracket removal” on page 4-25.
11. Remove the waste toner auger chute. See “Waste toner auger chute removal” on page 4-188.
12. Lift the appropriate plastic gate, and push it in to reduce toner spillage.
13. Detach the lower portion (A) of the auger from the appropriate developer housing.
To Next Page
Loading...
