Repair information 4-355
5058-030
10. Remove the two front screws and the two rear screws securing the bracket (C) to the finisher.
11. Remove the bracket (C).
12. Release the hook from the upper media exit roll drive gear 20T(D).
13. Remove the upper media exit roll drive gear 20T.
14. Remove the 6 mm bushing.
15. Use a prying tool to remove the e-clip securing the upper media exit roll assembly (F) to the front of the
finisher.
16. Remove the 6 mm bushing (E).
To Next Page
Loading...
