Repair information 4-397
5058-030
4
Adjust the 2 sheet staple position fine adjustment value as
shown in the graphic below:
1. Enter the diagnostic mode.
2. Touch ENGINE ADJUST.
3. Touch Booklet fold adjust.
4. Touch Booklet 2 sheet.
5. Make required staple position adjustments according to
media size.
1 step =.1 mm shift.
6. Touch Submit.
Print a 2 page booklet using the booklet maker.
Does the staple position fine adjustment appear to be offset
from the fold as shown in the graphic below?
Repeat step 2 until
the 2 sheet staple
position fine
adjustment is in
spec.
Problem solved.
Step Check Yes No
To Next Page
Loading...
