TDS5000B Online Programmer Guide
-- 11 1 --
CALibrate:RESults?
Description
This query--only command returns the status of internal and factory
calibrations, without performing any calibration operations. The results
returned do not include the calibration status of attached probes. The
CALibration:RESults? query is intended to support GO/NoGO testing
of the oscilloscope calibration readiness: all returned results should in-
dicate PASS status if the instrument is ”fit for duty”. It is quite com-
mon, however, to use uncalibrated probes (particularly when the instru-
mentt inputs are connected into a test system with coaxial cables).
This command is equivalent to selecting Instrument Calibration from
the Utilities menu and then viewing the contents of the Status field.
Group
Calibration
Related Commands
*CAL?
Syntax
CALibrate:RESults?
Example
CALibrate:RESults?
This query returns the status of all the calibration subsystems. The
query might return :
:CALIBRATE:RESULTS:SPC PASS;FACTORY PASS;FAC-
TORY:VOLTAGE PASS;FREQUENCY PASS;TRIGGER PASS
To Next Page
Loading...
Need help?
General
