Tektronix TDS5000B Series - Cursor:vbars:position<X

TDS5000B Online Programmer Guide
-- 1 5 4 --
CURSor:VBArs:POSITION<x>
Description
This command sets or queries the horizontal position for vertical bar
cursors. The cursor is specified by x, which can be 1 or 2. Values are
with respect to trigger position or the zero reference point for the desig-
nated waveform (if horizontal units are not set to time). Use the CUR-
Sor:VBArs:UNIts command to specify units. The position can appear
in units of base or 1/base.
This command is the equivalent of selecting Cursor Setup from the
Cursors menu, selecting V Bars Cursor Type, and then viewing or edit-
ing the desired cursor position.
Group
Cursor
Related Commands
CURSor:VBArs:UNIts
Syntax 1
CURSor:VBArs:POSITION<x> {<NR3>}
Syntax 2
CURSor:VBArs:POSITION<x>?
Argument
H <NR3>
Specifies the cursor position.
Returns
A floating point value with an exponent.
Example 1
CURSor:VBArs:POSITION2 9.00E-6
Positions the cursor2 vertical bar cursor at 9 ms.
Example 2
CURSor:VBArs:POSITION1?
This command might return
:CURSOR:VBARS:POSITION1 1.0000E-06
indicating that the cursor1 vertical bar is positioned at 1 ms.