TDS5000B Online Programmer Guide
-- 5 1 --
Vertical Command Group
Use the commands in the Vertical Command Group to control the verti-
cal setup of all live (channel) waveforms for acquisition and to control
the display of channel, reference, and math waveforms.
You may replace VOLts with SCAle in the vertical commands. This
provides program compatibility with earlier models of Tektronix instru-
ments.
Command Description
CH<x>? Returns vertical parameters for the speci-
fied channel
CH<x>:BANdwidth Sets or returns the bandwidth of the spe-
cified channel
CH<x>:COUPling Sets or returns the coupling setting for
the specified channel
CH<x>:DESKew Sets or returns the deskew time for the
specified channel
CH<x>:INVert Sets or returns the invert function for the
specified channel
CH<x>:LABel:NAMe Defines or returns the label for the chan-
nel waveform
CH<x>:LABel:XPOS Sets or returns the X display coordinate
for the channel waveform label
CH<x>:LABel:YPOS Sets or returns the Y display coordinate
for the channel waveform label
CH<x>:OFFSet Sets or returns the channel offset
CH<x>:POSition Sets or returns the channel vertical posi-
tion
CH<x>:PRObe? Returns the gain, resistance, units, and
ID of the probe that is attached to the
specified channel
CH<x>:PROBECal? Returns the probe calibration status
CH<x>:PRObe:GAIN? Returns the gain of the probe that is at-
tached to the specified channel
CH<x>:PRObe:ID? Returns the type and serial number of the
probe that is attached to the specified
channel
CH<x>:PRObe:ID:TYPe Returns the type of probe that is attached
to the specified channel
CH<x>:PRObe:ID:SERnumber? Returns the serial number of the probe
that is attached to the specified channel
CH<x>PRObe:RESistance? Returns the resistance of the probe that
is attached to the specified channel
CH<x>:PRObe:UNits? Returns the units of the probe that is at-
tached to the specified channel
CH<x>:PROBEFunc:EXTAtten Sets the attenuation value for the speci-
fied channel to the specified scale factor
Or returns the user--specified attenuation
CH<x>PROBEFunc:EXTDBatten Sets the attenuation value for the speci-
fied channel to the specified value, in
decibels
Or returns the user--specified attenuation,
in decibels
To Next Page
Loading...
Need help?
General
