Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 1 5 8 --
CURSor:WAVEform:POSition<x>
Description
This command sets or queries the position of a waveform cursor, which
is constrained to be visible in the selected time base. (Use the CUR-
Sor:FUNCtion command to set the cursor function to Waveform.) The
cursor is specified by x, which can be 1 or 2. This is equivalent to set-
ting a value in the Position control in the Cursor1 or Cursor2 sections of
the Cursor Setup dialog box (when Waveform is selected in the Func-
tion section).
Group
Cursor
Related Commands
CURSor:FUNCtion
Syntax 1
CURSor:WAVEform:POSition<x> {<NR3>}
Syntax 2
CURSor:WAVEform:POSition<x>?
Arguments
H <NR3>
Specifies the cursor position measured relative to the time of the trig-
ger point of the source waveform.
Example 1
CURSor:WAVEform:POSition2 9.00E-6
Example 2
CURSor:WAVEform:POSition2?
This query might return
:CURSOR:WAVEFORM:POSITION2 51.0701402806E-009
indicating waveform cursor 1 is at 51.1 ns.

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English