To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...
How to troubleshoot a Tektronix TDS5000B Test Equipment oscilloscope that will not power on?
If your Tektronix Test Equipment oscilloscope will not power on, first check the power cord connection to ensure it is properly plugged in. If the power cord is correctly connected, the issue might be a faulty power supply, which would require replacement.
What to do if the front panel light comes on but the fans won't operate on my Tektronix TDS5000B?
If the front panel light of your Tektronix Test Equipment comes on, but one or more fans are not operating, there are several potential causes: * A faulty fan cable: Inspect the fan cable and replace it if necessary. * A defective fan assembly: Replace the defective fan assembly. * A faulty power supply: Replace the faulty power supply.
General| Channels | 2 or 4 |
|---|---|
| Vertical Resolution | 8 bits |
| Display Type | Color LCD |
| Vertical Sensitivity | 1 mV/div to 10 V/div |
| Input Coupling | AC, DC, GND |
| Timebase Accuracy | ± 50 ppm |
| Operating Temperature | 0 °C to +50 °C |
| Bandwidth | up to 1 GHz |
| Sample Rate | up to 5 GS/s |
| Display Size | 10.4 inches |
| Input Impedance | 1 MΩ ± 1% |
| Trigger Types | Edge, Pulse Width, Logic, Runt, Timeout, Setup/Hold |
| Maximum Input Voltage | 300 V (DC + peak AC) |
| Interface | USB, GPIB, Ethernet |
