Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 5 0 2 --
MATH<x>:LABel:XPOS
Description
This command sets or queries the X screen offset at which the label
attached to a math waveform is displayed, relative to the left edge of
the screen. Channels are specified by x, which ranges from 1 through 4
for four--channel instruments or 1 through 2 for two--channel instru-
ments. This command is equivalent to selecting Math Label from the
Math menu and entering a value in the X Position box.
Group
Math
Related Commands
MATH<x>:LABel:YPOS
Syntax 1
MATH<x>:LABel:XPOS <NR1>
Syntax 2
MATH<x>:LABel:XPOS?
Argument
H <NR1>
This is the location (in pixels) where the label for the selected math
waveform is displayed, relative to the left edge of the screen. Argu-
ments should be integers ranging from 0 to 500.
Example 1
MATH2:LABel:XPOS 50
This command moves the waveform label for the MATH2 waveform
(on a four--channel instrurment) so that it begins 50 pixels to the right
of the left edge of the screen.
Example 2
MATH2:LABel:XPOS?
This query might return
:MATH2:LABEL:XPOS 50
indicating that the waveform label for the MATH2 waveform is current-
ly 50 pixels to the right of the left edge of the screen.