Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 4 8 0 --
MASK:TESt:STOP:FAILure
Description
This command sets or returns the stop status on pass/fail test failure
mode. When enabled, this command causes the oscilloscope to stop
acquiring data when the pass/fail status changes to ‘Failing’. In other
words, it stops when a failure occurs during the mask pass/fail test. Re-
peat--on--completion mode has no effect.
Group
Mask
Syntax 1
MASK:TESt:STOP:FAILure {OFF|ON|<NR1>}
Syntax 2
MASK:TESt:STOP:FAILure?
Arguments
H ON
Turns on the pass/fail stop on failure.
H OFF
Turns off the pass/fail stop on failure. This is the default.
H <NR1>
A 0 turns off the pass/fail stop on failure, and any other integer turns
on the pass/fail SRQ on failure.
Example
MASK:TEST:STOP:FAILURE OFF
Turns off the pass/fail stop on failure