Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 3 8 0 --
LIMit:Beep
Description
This command causes the instrument to beep when the waveform data
exceeds the limits set in the limit test (LIMit:STATE must be on).
Group
Limit Test
Related Commands
LIMit:STATE
Syntax 1
LIMit:BEEP {OFF|ON|<NR1>}
Syntax 2
LIMit:BEEP?
Arguments
H OFF
This argument disables the beep.
H ON
This argument enables the beep.
H <NR1>
A 0 disables the beep, any other value enables the beep.
Example 1
LIMit:BEEP ON
This command causes a beep when any waveform data exceeds the lim-
its specified in the limit test.
Example 2
LIMit:BEEP?
This query might return:
:LIMIT:BEEP 0
This indicates that the instrument will not beep when waveform data
exceeds the limits specified in the limit test.