TDS5000B Online Programmer Guide
-- 3 7 2 --
HORizontal:POSition
Description
This command either positions the waveform horizontally on the dis-
play or returns its horizontal position on the display. When Horizontal
Delay Mode is turned off, this command is equivalent to adjusting the
HORIZONTAL POSITION knob on the front panel.
Group
Horizontal
Related Commands
HORizontal[:MAIn]:DELay:MODe
Syntax 1
HORizontal:POSition <NR3>
Syntax 2
HORizontal:POSition?
Argument
H <NR3>
This is from 0 to ≈100 and is the percentage of the waveform that is
displayed left of the center graticule.
Note: The upper limit of the waveform position is slightly limited by
a value that is determined from the record length (upper limit = 100 --
1/record length).
Example 1
HORizontal:POSition 10
This command sets the horizontal position of the waveform such that
10% of the waveform is to the left of screen center.
Example 2
HORizontal:POSition?
This query might return:
:HORIZONTAL:POSITION 5.0000E+01
This indicates the horizontal position of the waveform on the screen.
To Next Page
Loading...
Need help?
General
