TDS5000B Online Programmer Guide
-- 1 3 0 --
CH<x>:PRObe:UNIts?
Description
This query--only command returns a string describing the units of mea-
sure for the probe attached to the specified channel. The channel is spe-
cified by x. The value of x can range from 1 through 4 for four--channel
instruments or 1 through 2 for two --channel instruments.
Group
Vertical
Related Commands
CH<x>:PROBEFunc:EXTUnits
Syntax
CH<x>:PRObe:UNIts?
Example
CH4:PRObe:UNIts?
This query might return
:CH4:PROBE:UNITS ”V”
indicating that the units of measure for the probe attached to channel 4
are volts.
To Next Page
Loading...
