Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 8 1 0 --
WFMInpre:YOFf
Description
This command sets or queries the vertical position of the incoming wa-
veform in digitizing levels. Variations in this number are analogous to
changing the vertical position of the waveform. For those formats in
which WFMInpre:BYT_Nr is important (all nonfloating point formats),
this command must take the location of the binary point implied by
BYT_NR into consideration.
Group
Waveform Transfer
Related Commands
WFMInpre:BYT_Nr, WFMInpre:YMUlt, WFMOutpre:YOFf
Syntax 1
WFMInpre:YOFf <NR3>
Syntax 2
WFMInpre:YOFf?
Argument
H <NR3>
This is the vertical offset in digitizing levels.
Example 1
WFMInpre:YOFf?
This query might return
:WFMINPRE:YOFF 25
indicating the vertical position of the incoming waveform in digitizing
levels.
Example 2
WFMInpre:YOFf 50
This command specifies that the zero reference point for the incoming
waveform is 50 digitizing levels (2 divisions) above the center of the
data range.

Tektronix TDS5000B Series Specifications

General

Channels	2 or 4
Vertical Resolution	8 bits
Display Type	Color LCD
Vertical Sensitivity	1 mV/div to 10 V/div
Input Coupling	AC, DC, GND
Timebase Accuracy	± 50 ppm
Operating Temperature	0 °C to +50 °C
Bandwidth	up to 1 GHz
Sample Rate	up to 5 GS/s
Display Size	10.4 inches
Input Impedance	1 MΩ ± 1%
Trigger Types	Edge, Pulse Width, Logic, Runt, Timeout, Setup/Hold
Maximum Input Voltage	300 V (DC + peak AC)
Interface	USB, GPIB, Ethernet