TDS5000B Online Programmer Guide
-- 3 1 9 --
HIStogram:BOXPcnt
Description
This command defines or queries the left, top, right, and bottom posi-
tions of the histogram box, in percentage coordinates. The upper left
has the value 0,0 and the lower right has the value 100, 100. Any value
outside the range of 0 to 100 is clipped. This command is similar to the
HIStogram:Box command except that this command uses percentage
coordinates to define the boundaries of the histogram box.
Note: This command implicitly clears the histogram count and statis-
tics for the histogram and histogram source data when HISto-
gram:STATE is turned on.
Group
HIStogram
Related Commands
HIStogram:Box
Syntax 1
HIStogram:BOXPcnt <NR3>, <NR3>, <NR3>, <NR3>
Syntax 2
HIStogram:BOXPcnt?
Arguments
H <NR3>
This specifies the left position of the histogram box in percentage
coordinates. The default value is 30.0.
H <NR3>
This specifies the top position of the histogram box in percentage
coordinates. The default value is 25.1.
H <NR3>
This specifies the right position of the histogram box in percentage
coordinates. The default value is 70.0.
H <NR3>
This specifies the bottom position of the histogram box in percentage
coordinates. The default value is 75.2.
To Next Page
Loading...
Need help?
General
