Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 4 7 1 --
MASK:TESt:REPeat
Description
This command sets or returns the repeat pass/fail test on completion
mode. When enabled, this command repeats the pass/fail test cycle at
the completion of the previous test cycle.
Group
Mask
Related Commands
MASK:COUNt:VIOLATIONS?
Syntax 1
MASK:TESt:REPeat {OFF|ON|<NR1>}
Syntax 2
MASK:TESt:REPeat?
Arguments
H ON
Turns on repeat on completion.
H OFF
Turns off repeat on completion
H <NR1>
A 0 turns off repeat on completion, and any other integer turns on
repeat on completion.
Example
MASK:TEST:REPEAT ON
Causes the oscilloscope to continuously repeat the pass/fail test.