TDS5000B Online Programmer Guide
-- 4 9 3 --
MASK:USER:SEG<m>:POINTS
Description
This command sets or returns the X --Y user coordinates of all points in
the specified User mask segment. The set form defines new points in
the User mask, replacing any existing points in the specified User mask
segment. In other words, it sets or returns the vertices for a particular
segment in the selected mask.
Group
Mask
Syntax 1
MASK:USER:SEG<m>:POINTS <NR3>, <NR3> [, <NR3>,
<NR3>]
Syntax 2
MASK:USER:SEG<m>:POINTS?
Arguments
H <m>
Is an integer that specifies the User mask segment number.
H <NR3>
Refers to the coordinates of one of the vertices in the User mask. Each
pair of numbers is the horizontal and vertical coordinates of a mask
segment vertex. The pairs must be listed in a counterclockwise order. If
the vertical or horizontal scale or position is changed after this com-
mand and then the query form of this command is issued, then the value
returned from the oscilloscope will not be the same. If just one pair is
input then they are ignored and the User mask segment is marked as
undefined. The default is not points in the User mask segment.
Example
MASK:USER:SEG2:POINTS –2.3e-9, 44e-3, -2.5e-9,
47e-3, 1.2e-9, 44e-3
Defines the points in User mask segment 2.
To Next Page
Loading...
Need help?
General
