TDS5000B Online Programmer Guide
-- 1 3 5 --
CH<x>:PRObe?
Description
This query--only command returns all information concerning the probe
that is attached to the specified channel. The channel is specified by x.
The value of x can range from 1 through 4 for four--channel instruments
or 1 through 2 for two--channel instruments.
Group
Vertical
Related Commands
CH<x>:PROBECal?
Syntax
CH<x>:PROBE?
Example
CH2:PROBE?
This query might return
:CH2:PROBE:GAIN 1.0000E-01; RESISTANCE
1.0000E+07;UNITS ”V”;ID:TYPE ”10X”’SERNUMBER
”N/A”
for a 10x probe, indicating that (among other parameters) the attenua-
tion factor for the probe attached to channel 2 is 100.0 mV (assuming
that probe units are set to volts).
To Next Page
Loading...
