Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 4 0 5 --
MASK:AUTOSet:HPOS
Description
This command controls whether the autoset algorithm will attempt to
change the horizontal position of the signal while attempting to autoset.
The default is ON.
This command, like all the MASK:AUTOSET commands, affects only
an autoset on a standard mask, not the general oscilloscope autoset
function.
Group
Mask
Syntax
MASK:AUTOSet:HPOS {ON|OFF|<NR1>}
Arguments
H ON
This enables the autoset:hpos function, causing … to occur.
H OFF
This disables the autoset:hpos function, causing … to occur.
H <NR1>
A 0 disables the autoset:hpos function; any other value disables en-
ables it.
Example
MASK:AUTOSet:HPOS ON
Enables the autoset:hpos function