TDS5000B Online Programmer Guide
-- 4 0 4 --
MASK:AUTOSet:AUTOAdjust
Description
This command sets or returns whether the instrument settings are auto-
matically matched to signal characteristics and specific mask require-
ments. It controls what happens at the end of a mask autoset. If ON, the
horz/vert auto adjustment is run ONCE to potentially improve the result
of mask autoset.
This command, like all the MASK:AUTOSET commands, affects only
an autoset on a standard mask, not the general oscilloscope autoset
function.
Group
Mask
Syntax 1
MASK:AUTOSet:AUTOAdjust {ON|OFF|<NR1>}
Syntax 2
MASK:AUTOSet:AUTOAdjust?
Arguments
H ON
This enables the autoset:autoadjust function.
H OFF
This disables the autoset:autoadjust function.
H <NR1>
A 0 disables the autoset:autoadjust function; any other value enables
it.
Example
MASK:AUTOSet:AUTOAdjust ON
Enables the autoset autoadjust function