Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 4 6 5 --
MASK:TESt:AUX:FAILure
Description
This command sets or returns the test:aux status on pass/fail test failure
mode. When enabled, this command causes the oscilloscope to send a
TTL signal out the AuxOut port when the pass/fail status changes to
‘Failing’. In other words, it sends the signal when a failure occurs dur-
ing the mask pass/fail test.
Group
Mask
Syntax 1
MASK:TESt:AUX:FAILure {OFF|ON|<NR1>}
Syntax 2
MASK:TESt:AUX:FAILure?
Arguments
H ON
Turns on the pass/fail mask:test:aux on failure.
H OFF
Turns off the pass/fail mask:test:aux on failure. This is the default.
H <NR1>
A 0 disables the mask:test:aux:failure function; any other value en-
ables it.
Example
MASK:TEST:AUX:FAILURE ON
Turns on the pass/fail test on failure