TDS5000B Online Programmer Guide
-- 4 7 2 --
MASK:TESt:SAMple
Description
This command sets or returns the minimum number of waveform data-
base (WfmDB) points the oscilloscope can acquire before it stops a
single sequence acquisition or stops running a mask test.
Hint: a bigger sample size may allow a greater throughput (more wave-
forms to get acquired at a time). However, a very large sample size may
slow down the display update. So if you find yourself wanting to speed
up the display rate, consider reducing the sample size.
This command works the same as the ACQuire:NUMSAMples com-
mand.
Group
Mask
Syntax 1
MASK:TESt:SAMple {<NR1>}
Syntax 2
MASK:TESt:SAMple?
Arguments
H <NR1>
The number of points to sample.
Example
MASK:TEST:SAMPLE 100000
Sets the oscilloscope to acquire 100,000 WfmDB points.
To Next Page
Loading...
Need help?
General
