TDS5000B Online Programmer Guide
-- 7 9 3 --
VERBose
Description
This command sets or queries the Verbose state that controls the length
of keywords on query responses. Keywords can be both headers and
arguments.
Note: This command does not affect IEEE Std 488.2--1987 Common
Commands (those starting with an asterisk). However, this command
does make a corresponding change in the Response Header Enable
State of the opposite interface (physical or virtual GPIB interface). Re-
fer to Introduction for more information.
Group
Miscellaneous
Related Commands
HEADer, *LRN?, SET?
Syntax
VERBose {OFF|ON|<NR1>}
Arguments
H OFF
This sets the Verbose state to true, which returns full--length keywords
for applicable setting queries.
H ON
This sets the Verbose state to false, which returns minimum--length
keywords for applicable setting queries.
H <NR1>
A 0 returns minimum--length keywords for applicable setting queries;
any other value returns full --length keywords.
Example 1
VERBose ON
This command enables the Verbose state.
Example 2
VERBOSE?
This query might return
:VERBOSE 0
indicating that the Verbose state is disabled.