TDS5000B Online Programmer Guide
-- 2 7 2 --
EMail:MEASurement
Description
This command sets or queries whether measurement data is included as
an attachment to e--mail. You must specify the saved measurement
selection (for all displayed measurements, measurement snapshots, or
histogram data) and the measurement format using the Email on Event
setup menu. There are no remote commands for this purpose.
Group
Email
Syntax 1
EMail:MEASurement {ON|OFF|NR1}
Syntax 2
EMail:MEASurement?
Arguments
H ON
This enables the inclusion of measurement data in e--mail.
H OFF
This disables the inclusion of measurement data in e--mail.
H <NR1>
A 0 disables the inclusion of measurement data in the e--mail; any
other value enables including measurement data in the e--mail.
Example 1
EMail:MEASurement 1
This command enables the inclusion of measurement data in e--mail.
Example 2
EMail:MEASurement?
This query might return
:EMAIL:MEASUREMENT 0
This indicates that measurement data is not included in the e--mail.
To Next Page
Loading...
Need help?
General
