TDS5000B Online Programmer Guide
-- 6 6 3 --
TRIGger:A:COMMunication:STANdard
(Option SM Only)
Description
This command sets or queries the standard that identifies the code and
bit rate. The bit rate is used to compute the Unit Interval, which is the
inverse of the bit rate. The Unit Interval influences time skew in an Eye
Diagram, where you do post processing on AMI isolated pulses, and
pulse width settings if CMI.
Group
Trigger
Related Commands
MASK:STANdard
Syntax 1
TRIGger:A:COMMunication:STANdard
{ATAG1|ATAG2|ATAG3|DSOContra|
DSODoubleDSOSingle|DSOTiming|
DS1|DS1A|DS1C|DS2|DS2RATESymmetrical|
DS2RATECoax|RATE32Mbit|RATE97Mbit|
DS3|DS4NA|E1|E2|E3|E4|STS1|STS3|STM1E|
FC133|FC266|FC531|1063|FC2125|OC1|OC3|
OC12|OC48|OC48_FEC|STM1E|ENET100|ENET1250|
ENETXAUI|INF2_5G|FST|HST|FW1394BS400B
|FW1394BS1600B |Custom|RIO_500M|RIO_750M|
RIO_1G|RIO_1_5G|RIO_2G|RIO_SERIAL_1G|
RIO_SERIAL_2G|RIO_SERIAL_3G|SFI5_2|
RATE32Mbit|RATE97Mbit|SFI5_3|VSROC192|
TFI5_2|TFI5_3|PCIExpress}
Syntax 2
TRIGger:A:COMMunication:STANdard?
Arguments
The following table shows various standards and their corresponding
parameters.
To Next Page
Loading...
Need help?
General
