TDS5000B Online Programmer Guide
-- 1 6 8 --
CURSor:XY:RATIO<x>?
Description
This query--only command returns ratio the of the X (horizontal) and Y
(vertical) position for the specified cursor when the CUR-
Sor:XY:READOUT is set to RATio. The cursor is specified by x, which
can be 1 or 2. The ratio is calculated as Y ÷ X.
Note: This query is only valid when the CURSor:XY:READOUT is
set to RATio. If the readout is set other than ratio, the IEEE represen-
tation of NAN (Not a Number) is returned: 99.1000E+36.
Group
Cursor
Syntax
CURSor:XY:RATIO<x>?
Example
CURSor:XY:RATIO1?
This query might return
:CURSOR:XY:RATIO1 15.8730E-3
indicating that the ratio of the X and Y positions for Cursor 1 is
15.8730E–3.
To Next Page
Loading...
