TDS5000B Online Programmer Guide
-- 7 1 2 --
TRIGger:A:PULse:GLItch:TRIGIF
Description
This command sets or queries the acceptance/rejection of the glitch
pulse trigger, based on width. This command is equivalent to selecting
Glitch Setup from the Trig menu and choosing the desired Trig if Width
setting.
Group
Trigger
Related Commands
TRIGger:A:PULse:GLItch:WIDth
Syntax 1
TRIGger:A:PULse:GLItch:TRIGIF {ACCept|REJect}
Syntax 2
TRIGger:A:PULse:GLItch:TRIGIF?
Arguments
H ACCept
This specifies that the instrument will only trigger on pulses that are
narrower than the specified width, when the trigger type is set to
glitch. The width is specified using the TRIG-
ger:A:PULse:GLItch:WIDth command.
H REJect
This specifies that the instrument will only trigger on pulses that are
wider than the specified width, when the trigger type is set to glitch.
The width is specified using the TRIGger:A:PULse:GLItch:WIDth
command.
Example 1
TRIGger:A:PULse:GLItch:TRIGIF?
This query might return
:TRIGGER:A:PULSE:GLITCH:TRIGIF ACCEPT
indicating that the instrument is set to trigger on pulses that are narrow-
er than the specified width.
Example 2
TRIGger:A:PULse:GLItch:TRIGIF REJect
This command specifies that the instrument triggers on pulses that are
wider than the specified width.
To Next Page
Loading...
Need help?
General
