TDS5000B Online Programmer Guide
-- 4 6 8 --
MASK:TESt:DELay
Description
This command sets or returns the amount of time, in seconds, to wait
after starting pass/fail testing to evaluate waveforms. This is useful if
the test system requires ‘settling’ time prior to evaluating waveforms.
Group
Mask
Syntax 1
MASK:TESt:DELay <NR3>
Syntax 2
MASK:TESt:DELay?
Argument
H <NR3>
Is a floating point number that specifies the amount of time, in sec-
onds, to delay the start of the pass/fail test.
Example
MASK:TEST:DELAY 1
Delays waveform evaluation by 1 second after the start of pass/fail test-
ing.
To Next Page
Loading...
Need help?
General
