Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 4 7 8 --
MASK:TESt:STATE
Description
This command sets or returns the state of mask pass/fail testing. When
enabled, this command resets the pass/fail status information and starts
pass/fail mask testing. This command also generates an ‘Operation
Complete’ message when pass/fail testing completes. Refer to BUSY?
And *OPC commands for information on synchronizing a controller
with pass/fail testing.
Group
Mask
Syntax 1
MASK:TESt:STATE {OFF|ON|<NR1>}
Syntax 2
MASK:TESt:STATE?
Arguments
H ON
Turns on mask pass/fail testing.
H OFF
Turns off mask pass/fail testing.
H <NR1>
A 0 turns off mask pass/fail testing; any other integer turns on mask
pass/fail testing.
Example
MASK:TEST:STATE ON
Turns on mask pass/fail testing.