TDS5000B Online Programmer Guide
-- 8 7 6 --
Factory Default Setup Values
Default Setup
The following tables list the default setup values by command group.
The instrument sets these values when you press the front--panel DE-
FAULT SETUP button or sending the FACtory command. Only those
commands that have values set by the DEFAULT SETUP function are
listed in these tables.
Note: The following commands do not affect the DATa parameters:
TEKSecure, *RST, RECALL:SETUP FACtory. These are the initial
factory default settings for DATa :DATA:DESTINATION
REF1;ENCDG RIBINARY;SOURCE CH1;START 1;STOP
5000;FRAMESTART 1;FRAMESTOP 5000.
Acquisition Default Values
The following table lists the Acquisition factory default setup values.
Command Default Values
ACQUIRE:MODE SAMPLE
ACQUIRE:NUMAVG 16
ACQUIRE:NUMENV 10
ACQUIRE:NUMSAMPLES 16000
ACQUIRE:SAMPLINGMODE IT
ACQUIRE:STATE 1 (ON)
ACQUIRE:STOPAFTER RUNSTOP
FASTACQ:STATE 0
Alias Default Values
The following table lists the Alias factory default setup values.
Command Default Values
ALIAS:STATE 0 (OFF)
To Next Page
Loading...
