Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 8 7 7 --
Cursor Default Values
The following table lists the Cursor factory default setup values.
Command Default Values
CURSOR:FUNCTION VBARS
CURSOR:HBARS:POSITION1 300.0000E-3
CURSOR:HBARS:POSITION2 -300.0000E-3
CURSOR:LINESTYLE SOLID
CURSOR:MODE INDEPENDENT
CURSOR:PAIRED:POSITION1 -1.6000E-6
CURSOR:PAIRED:POSITION2 1.6000E-6
CURSOR:SCREEN:STYLE LINES
CURSOR:SOURCE1 CH1
CURSOR:SOURCE2 CH1
CURSOR:STATE 0
CURSOR:VBARS:POSITION1 -1.6000E-6
CURSOR:VBARS:POSITION2 1.6000E-6
CURSOR:VBARS:UNITS SECONDS
CURSOR:WAVEFORM:POSITION1 -1.6000E-6
CURSOR:WAVEFORM:POSITION2 1.6000E-6
CURSOR:WAVEFORM:SOURCE2 CH1
CURSOR:WAVEFORM:STYLE LINE_X
CURSOR:WAVEFORM:UNITS BASE
CURSOR:XY:READOUT RECTANGULAR
CURSOR:XY:RECTX1 0.0000
CURSOR:XY:RECTX2 0.0000
CURSOR:XY:RECTY1 0.0000
CURSOR:XY:RECTY2 0.0000