Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 1 6 3 --
CURSor:WAVEform
Description
This command returns the current settings for the waveform cursors or
forces them to snap to positions specified by the DATA:START and
DATA:STOP commands.
Group
Cursor
Related Commands
DATA:START, DATA:STOP
Syntax 1
CURSor:WAVEform?
Returns the units and positions of the waveform cursors.
Syntax 2
CURSor:WAVEform SNAp
Argument
H SNAp
Forces the position of waveform cursor 1 and 2 to snap to the wave-
form record points specified by the DATA:START and DATA:STOP
commands, respectively.
Example 1
CURSor:WAVEform?
This query might return the following waveform cursor settings
:CURSOR:WAVEFORM:UNITS SECONDS;POSITION1
1.0000E-06;POSITION2 9.0000E-06
Example 2
CURSor:WAVEform SNAp
This command forces waveform cursor1 to the DATA:START position
and waveform cursor2 to the DATA:STOP position.

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English