Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 3 1 7 --
HIStogram:Box
Description
This command defines or returns the left, top, right, and bottom bound-
aries of the histogram box, in source waveform coordinates. This com-
mand is equivalent to selecting Waveform Histograms from the Mea-
sure menu and then setting Limits for Left, Right, Top, and Bottom in
the appropriate boxes. The command is similar to the HISto-
gram:BOXPcnt command except that command uses percentage coor-
dinates to define the boundaries of the histogram box.
Note: This command implicitly clears the histogram count and statis-
tics for the histogram and histogram source data when HISto-
gram:STATE is turned on.
Group
Histogram
Related Commands
HIStogram:BOXPcnt
Syntax 1
HIStogram:Box <NR3>,<NR3>,<NR3>,<NR3>
Syntax 2
HIStogram:Box?
Arguments
H <NR3>
This specifies the left position of the histogram box in source wave-
form coordinates.
H <NR3>
This specifies the top position of the histogram box in source wave-
form coordinates.
H <NR3>
This specifies the right position of the histogram box in source wave-
form coordinates.
H <NR3>
This specifies the bottom position of the histogram box in source wa-
veform coordinates.
Example 1
HIStogram:Box 1E-9, 0.250, 2E-9, 0.500
This command defines the coordinates of the histogram box in source
waveform coordinates.

Tektronix TDS5000B Series Specifications

General

Channels	2 or 4
Vertical Resolution	8 bits
Display Type	Color LCD
Vertical Sensitivity	1 mV/div to 10 V/div
Input Coupling	AC, DC, GND
Timebase Accuracy	± 50 ppm
Operating Temperature	0 °C to +50 °C
Bandwidth	up to 1 GHz
Sample Rate	up to 5 GS/s
Display Size	10.4 inches
Input Impedance	1 MΩ ± 1%
Trigger Types	Edge, Pulse Width, Logic, Runt, Timeout, Setup/Hold
Maximum Input Voltage	300 V (DC + peak AC)
Interface	USB, GPIB, Ethernet