TDS5000B Online Programmer Guide
-- 1 2 4 --
CH<x>:PROBECal?
Description
This query--only command returns the probe calibration state for the
selected channel. The channel is specified by x. The value of x can
range from 1 through 4 for four --channel instruments or 1 through 2 for
two--channel instruments. This command is equivalent to selecting
Probe Cal from the Vertical menu.
Group
Vertical
Related Commands
Syntax
CH<x>:PROBECal?
Outputs
H FAIl
This signifies that the probe calibration has failed for the selected
channel.
H INIT
This signifies that the probe calibration has not yet been run for the
selected channel.
H PASS
This signifies the probe calibration has passed for the selected chan-
nel.
Example
CH2:PROBECal?
This query might return
:CH2:PROBECAL PASS
indicating that the probe calibration has passed for channel 2.
To Next Page
Loading...
