TDS5000B Online Programmer Guide
-- 2 5 7 --
DISplay:TRIGBar
Description
This command controls or queries the display of the trigger--level indi-
cator bar/s. Indicator bars show where the trigger voltage level is set.
The instrument will only display the bar if the associated trigger source
is also displayed. If both a main and a delayed trigger are displayed,
then two bars will appear. One will accompany each source. If a logic
trigger is selected, then multiple bars may appear. One will show the
upper threshold and one will show the lower threshold. This command
is equivalent to selecting Display Setup from the Display menu and
then choosing the Objects tab.
Group
Display Control
Syntax 1
DISplay:TRIGBar {OFF|SHORt|LONG}
Syntax 2
DISplay:TRIGBar?
Arguments
H OFF
This removes the trigger indicator bar from the display.
H SHORt
This displays, as the indicator, a short arrow at the right side of the
graticule for each displayed trigger signal.
H LONG
This displays, as the indicator, a horizontal line across the width of the
graticule for each displayed trigger signal.
Example 1
DISplay:TRIGBar LONG
This command sets the display to show a long trigger indicator bar (or
bars).
Example 2
DISplay:TRIGBar?
This query might return:
:DISPLAY:TRIGBAR OFF,
This indicates that the indicator bar is removed from the display.
To Next Page
Loading...
Need help?
General
