Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 4 6 7 --
MASK:TESt:BEEP:FAILure
Description
This command sets or returns the beep status on pass/fail test failure
mode. When enabled, this command causes the oscilloscope to emit a
tone when the pass/fail status changes to ‘Failed’. In other words, it
sounds the bell when a failure occurs during the mask pass/fail test.
Group
Mask
Syntax 1
MASK:TESt:BEEP:FAILure {OFF|ON|<NR1>}
Syntax 2
MASK:TESt:BEEP:FAILure?
Arguments
H ON
Turns on the pass/fail beep on failure.
H OFF
Turns off the pass/fail beep on failure. This is the default.
H <NR1>
A 0 turns off the pass/fail beep on failure, and any other integer turns
on the pass/fail beep on failure.
Example
MASK:TEST:BEEP:FAILURE OFF
Turns off the pass/fail beep on failure