TDS5000B Online Programmer Guide
-- 1 2 0 --
CH<x>:LABel:YPOS
Description
This command sets or queries the Y screen offset at which the label
(attached to the displayed waveform of the specified channel) is dis-
played, relative to the top edge of the screen. The channel is specified
by x. The value of x can range from 1 through 4 for four--channel in-
struments or 1 through 2 for two --channel instruments. This command
is equivalent to selecting Label from the Vertical menu and either view-
ing or setting Y Pos.
Group
Vertical
Syntax 1
CH<x>:LABel:YPOS <NR1>
Syntax 2
CH<x>:LABel:YPOS?
Argument
H <NR1>
This is the location (in pixels) where the waveform label for the se-
lected channel is displayed, relative to the top edge of the screen. Ar-
guments should be integers ranging from 0 to 385.
Example 1
CH3:LABel:YPOS -25
This command moves the waveform label for the CH3 waveform to just
beneath (25 pixels below) the top of the screen.
Example 2
CH2:LABel:YPOS?
This query might return
:CH2:LABEL:YPOS 0
indicating that the waveform label for the CH2 waveform is currently
located just beneath the top of the screen.
To Next Page
Loading...
Need help?
General
