Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 1 7 2 --
CURSor:XY:RECTY<x>
Description
This command sets or queries the Y cursor position in rectangular coor-
dinates. The cursor is specified by x, which can be 1 or 2.
Note: This query is only valid when the CURSor:XY:READOUT is
set to RECTangular. If the readout is set to other than rectangular
coordinates, the IEEE representation of NAN (Not a Number) is re-
turned: 99.1000E+36.
Group
Cursor
Syntax 1
CURSor:XY:RECTY<x> {<NR3>}
Syntax 2
CURSor:XY:RECTY<x>?
Arguments
H <NR3>
This is the Y position of the specified cursor in rectangular coordi-
nates.
Example 1
CURSor:XY:RECTY1 2.5
This command sets the Y position of Cursor 1 to 2.5 V.
Example 2
CURSor:XY:RECTY2?
This query might return
:CURSOR:XY:RECTY2 4.8800
indicating that the position of Cursor 2 in rectangular coordinates is
4.88 V.

Tektronix TDS5000B Series Specifications

General

Channels	2 or 4
Vertical Resolution	8 bits
Display Type	Color LCD
Vertical Sensitivity	1 mV/div to 10 V/div
Input Coupling	AC, DC, GND
Timebase Accuracy	± 50 ppm
Operating Temperature	0 °C to +50 °C
Bandwidth	up to 1 GHz
Sample Rate	up to 5 GS/s
Display Size	10.4 inches
Input Impedance	1 MΩ ± 1%
Trigger Types	Edge, Pulse Width, Logic, Runt, Timeout, Setup/Hold
Maximum Input Voltage	300 V (DC + peak AC)
Interface	USB, GPIB, Ethernet