Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 5 9 8 --
MEASUrement:MEAS<x>?
Description
This query--only command returns all measurement parameters for the
displayed measurement specified by x, which can range from 1 through
8. This query command is equivalent to selecting Measurement Setup
from the Measure menu and viewing the Measurements table; then
choosing the Time tab, clicking the Delay button and viewing the Delay
Edge and Search Direction settings.
Group
Measurement
Syntax
MEASUrement:MEAS<x>?
Example
MEASUrement:MEAS1?
This query might return
:MEASUREMENT:MEAS1:STATE 0;TYPE UNDE-
FINED;UNITS ”V”;SOURCE1 CH1;SOURCE2
CH1;SOURCE1:SIGTYPE PULSE;:MEA-
SUREMENT:MEAS1:SOURCE2:SIGTYPE PULSE;:MEA-
SUREMENT:MEAS1:DELAY:EDGE1 RISE;EDGE2 RISE;
DIRECTION FORWARDS;:MEASUREMENT:MEAS1:REFLE-
VEL:METHOD PERCENT;ABSOLUTE:HIGH 0.0000;LOW
0.0000;MID1 0.0000;MID2 0.0000;:MEA-
SUREMENT:MEAS1:REFLEVEL:PERCENT:HIGH
90.0000;LOW 10.0000;MID1 50.0000;MID2
50.0000;:MEASUREMENT:MEAS1:METHOD HISTO-
GRAM;NOISE HIGH.