Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 4 6 6 --
MASK:TESt:BEEP:COMPLetion
Description
This command sets or returns the beep on pass/fail test completion
mode. When enabled, this command causes the oscilloscope to emit a
tone when the mask pass/fail test completes.
Group
Mask
Syntax 1
MASK:TESt:BEEP:COMPLetion {OFF|ON|<NR1>}
Syntax 2
MASK:TESt:BEEP:COMPLetion?
Arguments
H ON
Turns on the pass/fail beep on completion.
H OFF
Turns off the pass/fail beep on completion.
H <NR1>
A 0 turns off the pass/fail beep on completion, any other integer turns
on the pass/fail beep on completion.
Example
MASK:TEST:BEEP:COMPLETION ON
Turns on pas/fail beep on completion