Tektronix TDS5000B Series - Limit:template:tolerance:vertical

TDS5000B Online Programmer Guide
-- 3 9 7 --
LIMit:TEMPLate:TOLerance:VERTical
Description
This command sets or queries the amount, in units of vertical divisions,
by which the source waveform is varied vertically when creating the
destination waveform.
Group
Limit Test
Related Commands
Syntax 1
LIMit:TEMPLate:TOLerance:VERTical <tolerance>
Syntax 2
LIMit:TEMPLate:TOLerance:VERTical?
Argument
H <tolerance>
This argument is the amount, in vertical divisions, by which the cur-
rent source waveform is allowed to deviate from the template wave-
form without exceeding the limits set in the limit test. The range is 0
to 5 divisions.
Example 1
LIMit:TEMPLate:TOLerance:VERTical 1.0
This command specifies that the current waveform is close enough to
the template waveform if it is within ±1.0 vertical division.
Example 2
LIMit:TEMPLate:TOLerance:VERTical?
This query might return:
:LIMit:TEMPLate:TOLerance:VERTical 2.0
This indicates that the current waveform is close enough to the template
waveform if it is within ±2.0 vertical divisions.