Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 4 1 8 --
MASK:AUTOSet:VPOS
Description
This command controls whether the autoset algorithm will affect the
vertical position (or offset) of the signal while attempting to autoset.
The default is ON.
This command, like all the MASK:AUTOSET commands, affects only
an autoset on a standard mask, not the general oscilloscope autoset
function.
Group
Mask
Syntax
MASK:AUTOSet:VPOS {ON|OFF|<NR1>}
Arguments
H ON
This enables the autoset:vpos function.
H OFF
This disables the autoset:vpos function.
H <NR1>
A 0 disables the autoset:vpos function; any other value enables it.
Example
MASK:AUTOSet:VPOS ON
Enables the autoset:vpos function