Tektronix TDS5000B Series - Measurement:meas<X>:State

TDS5000B Online Programmer Guide
-- 5 8 7 --
MEASUrement:MEAS<x>:STATE
Description
This command sets or queries whether the specified measurement slot
is computed and displayed. The measurement slot is specified by x,
which ranges from 1 through 8. This command is equivalent to select-
ing Measurement Setup from the Measure menu and then clicking the
Display button.
For a measurement to display, you must have selected a source wave-
form and defined the measurement you want to take and display. You
select the measurement using the MEASUre-
ment:MEAS<x>:SOURCE[1] command. You define the measurement
type using the MEASUrement:MEAS<x>:TYPe command.
Group
Measurement
Related Commands
MEASUrement:MEAS<x>:SOURCE[1], MEASUre-
ment:MEAS<x>:TYPe
Syntax 1
MEASUrement:MEAS<x>:STATE {OFF|ON|<NR1>}
Syntax 2
MEASUrement:MEAS<x>:STATE?
Arguments
H OFF
This disables calculation and display of the specified measurement
slot.
H ON
This enables calculation and display of the specified measurement
slot.
H <NR1>
A 0 disables calculation and display of the specified measurement
slot; any other value enables calculation and display of the specified
measurement slot.
Example 1
MEASUrement:MEAS2:STATE ON
This command computes and displays the measurement defined as
measurement 2.