Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 5 6 9 --
MEASUrement:MEAS<x>:DELay:EDGE[1]
Description
This command sets or queries the slope of the edge that is used for the
delay ”from” waveform when taking a delay measurement. Use the
MEASUrement:MEAS<x>:SOURCE[1] command to specify the wa-
veform. This command is equivalent to selecting Time from the Mea-
sure menu, choosing Delay from the drop --down list and clicking the
desired Delay Edge1 setting. Measurements are specified by x, which
ranges from 1 through 8.
Group
Measurement
Related Commands
MEASUrement:MEAS<x>:SOURCE[1]
Syntax 1
MEASUrement:MEAS<x>:DELay:EDGE[1] {FALL|RISe}
Syntax 2
MEASUrement:MEAS<x>:DELay:EDGE[1]?
Arguments
H FALL
This specifies the falling edge of the waveform.
H RISe
This specifies the rising edge of the waveform.
Example 1
MEASUrement:MEAS3:DELay:EDGE[1] RISe
This command specifies that the rising edge of the waveform be used
for measurement 3.
Example 2
MEASUrement:MEAS1:DELay:EDGE[1]?
This query might return
:MEASUREMENT:MEAS1:DELAY:EDGE[1] FALL
indicating that the falling edge of the waveform is being used for mea-
surement 1.