TDS5000B Online Programmer Guide
-- 5 7 0 --
MEASUrement:MEAS<x>:DELay:EDGE2
Description
This command sets or queries the slope of the edge that is used for the
delay ”to” waveform when taking a delay measurement. Use the MEA-
SUrement:MEAS<x>:SOURCE2 command to specify the waveform.
This command is equivalent to selecting Time from the Measure menu,
choosing Delay from the drop --down list and then clicking the desired
Delay Edge2 setting. Measurements are specified by x, which ranges
from 1 through 8.
Group
Measurement
Related Commands
MEASUrement:MEAS<x>:SOURCE2
Syntax 1
MEASUrement:MEAS<x>:DELay:EDGE2 {FALL|RISe}
Syntax 2
MEASUrement:MEAS<x>:DELay:EDGE2?
Arguments
H FALL
This specifies the falling edge of the waveform.
H RISe
This specifies the rising edge of the waveform.
Example 1
MEASUrement:MEAS3:DELay:EDGE2 RISe
This command specifies that the rising edge of the waveform be used
for measurement 3.
Example 2
MEASUrement:MEAS1:DELay:EDGE2?
This query might return
:MEASUREMENT:MEAS1:DELAY:EDGE2 FALL
indicating that the falling edge of the waveform is being used for mea-
surement 1.
To Next Page
Loading...
