Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 3 6 3 --
HORizontal[:MAIn]:DELay:POSition
Description
This command sets or queries the time base position when Horizontal
Delay Mode is turned on. This command is equivalent to selecting Hor-
izontal/Acquisition Setup from the Horiz/Acq menu and then entering a
Ref Point value.
Group
Horizontal
Related Commands
HORizontal[:MAIn}:DELay:TIMe
Syntax 1
HORizontal[:MAIn]:DELay:POSition <NR3>
Syntax 2
HORizontal[:MAIn]:DELay:POSition?
Arguments
H <NR3>
This is from 0 to ≈100 and is the percentage of the waveform that is
displayed left of the center graticule.
Note: The upper limit of the waveform position is slightly limited by
a value that is determined from the record length (upper limit = 100 --
1/record length).
Example 1
HORizontal:DELay:POSition 5E+1
This command sets the time base trigger delay position to 50 percent.
Example 2
HORizontal:DELay:POSition?
This query might return
:HORIZONTAL:MAIN:DELAY:POSITION 5.0000E+01
This indicates that the time base trigger delay position is currently set to
50 percent.

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English