Tektronix TDS5000B Series Online Programmer Guide

TDS5000B Online Programmer Guide
-- 1 5 5 --
CURSor:VBArs:UNIts
Description
This command sets or queries the units for the vertical bar cursors.
Group
Cursor
Syntax 1
CURSor:VBArs:UNIts {SEConds|HERtz}
Syntax 2
CURSor:VBArs:UNIts?
Arguments
H SECOnds
Sets the units of the vertical bar cursors for the time domain (sec-
onds).
H HERtz
Sets the units of the vertical bar cursors for the frequency domain
(hertz).
Returns
A string for SECOnds or HERtz, depending on the current vertical bar
cursor units.
Example 1
CURSor:VBArs:UNIts HERtz
Sets the units of the VBArs cursors to 1/seconds.
Example 2
CURSor:VBArs:UNIts?
This command might return
:CURSOR:VBARS:UNITS SECONDS
indicating that the units for the vertical bar cursor are currently set to
seconds.

Tektronix TDS5000B Series Specifications

General

Channels	2 or 4
Vertical Resolution	8 bits
Display Type	Color LCD
Vertical Sensitivity	1 mV/div to 10 V/div
Input Coupling	AC, DC, GND
Timebase Accuracy	± 50 ppm
Operating Temperature	0 °C to +50 °C
Bandwidth	up to 1 GHz
Sample Rate	up to 5 GS/s
Display Size	10.4 inches
Input Impedance	1 MΩ ± 1%
Trigger Types	Edge, Pulse Width, Logic, Runt, Timeout, Setup/Hold
Maximum Input Voltage	300 V (DC + peak AC)
Interface	USB, GPIB, Ethernet