Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 1 4 4 --
CURSor:HBArs:POSITION<x>
Description
This command sets or queries the horizontal bar cursor position relative
to ground, which is expressed in vertical units (usually volts). The cur-
sor is specified by x, which can be 1 or 2. This command is the equiva-
lent to selecting Cursor Position from the Cursors menu, selecting the H
Bars Cursor Type, and then viewing or editing the desired cursor posi-
tion.
Group
Cursor
Related Commands
CURSor:FUNCtion
Syntax 1
CURSor:HBArs:POSITION<x> <NR3>
Syntax 2
CURSor:HBArs:POSITION<x>?
Argument
H <NR3>
Specifies the cursor position relative to ground.
Example 1
CURSOR:HBARS:POSITION1 25.0E-3
This command positions Cursor 1 of the horizontal cursors at 25 mV.
Example 2
CURSOR:HBARS:POSITION2?
This query might return
:CURSOR:HBARS:POSITION2 -64.0000E-03
indicating that Cursor 2 of the horizontal bar cursors is at --64 mV.