Tektronix TDS5000B Series

TDS5000B Online Programmer Guide
-- 4 7 7 --
MASK:TESt:SRQ:FAILure
Description
This command sets or returns the SRQ status on pass/fail test failure
mode. When enabled, this command causes the oscilloscope to send a
GPIB SRQ command when the pass/fail status changes to ‘Failing’. In
other words, it sends an SRQ when a failure occurs during the mask
pass/fail test.
Group
Mask
Syntax 1
MASK:TESt:SRQ:FAILure {OFF|ON|<NR1>}
Syntax 2
MASK:TESt:SRQ:FAILure?
Arguments
H ON
Turns on the pass/fail SRQ on failure.
H OFF
Turns off the pass/fail SRQ on failure. This is the default.
H <NR1>
A 0 turns off the pass/fail SRQ on failure, and any other integer turns
on the pass/fail SRQ on failure.
Example
MASK:TEST:SRQ:FAILURE OFF
Turns off the pass/fail SRQ on failure